GCL-MH

UL325-2010 APPROVED

• Allows for monitored entrapment connections for protection and momentary operation when used with select photo eyes and/or edge-sensing devices.
• Approved monitored devices

GCL-MH Advantages

• Rated for 15 cycles per hour operation, maximizing the performance of a medium-duty operator.
• Modular design with optional expansion boards for advanced timer to close, and auxiliary output functionality.
• Optional Intellicode^® plug and play receiver learns up to 50 transmitters. Learn and delete individual transmitters directly from LCD display.
• TensiBelt^® primary drive reduction eliminates need to adjust belt tension.
• Available in either 115V or 230V AC single phase 60Hz. Expanded offering increases applications available for medium-duty use.
• Motor with built-in thermal protection and ball bearing drive end. Provides overload protection and bearings extend life of motor over typical bushings.
• LCD display with intuitive setup menu. Provides real-time status and trouble-shooting assistance.
• Open/close/stop and setup keys included on control board. Keeps all controls near the LCD display convenient for set up.

• Motor
  1/2 HP, AC capacitor start/run motor. Motor replaceable without changing limits.
• Brake
  AC solenoid actuated band brake.
• Drive
  
  • Primary - TensiBelt^TM auto tensioning poly-V J-belt.
  • Secondary - Chain and sprocket reduction
• Friction Clutch
  Adjustable clutch to help protect against door and operator damage.
• Precision Radial Ball Bearings
  Incuded in critical areas throughout the powertrain.
• Emergency Hoist Manual Operation
  Electrically interlocked manual hoist with floor level disconnect.
• Pre-wired to accept:
  
  • Monitored entrapment device such as photo eyes.
  • Single or 3-button control stations.
  • External interlock switches

• Timer to Close Module
  Timed close set via the LCD display from 2 seconds up to 5 minutes. Includes pre-close warning contacts, timer hold input, auxiliary open input, normally closed safety input, and monitored edge input.
• Auxiliary Output Module
  Provides relay contacts at the open, close, and mid-stop limits. Contacts for 5-minute lamp, and "ADA" contacts set via LCD display to warn during opening, closing or both.
• 315Mhz Receiver Module
  Intellicode^® I radio receiver that is 315Mhz and capable of storing 50 single-button and/or 50 open-close-stop transmitters with the ability to add or delete transmitters and identify and store activating transmitter ID(s).
• UL325-2010 Approved Reversing Devices
  The installation of a monitored external entrapment device is required for momentary contact close operation on all commercial door operators. Only the following devices, when purchased through Genie, are UL-approved for use to meet this requirement:
  • Safe-T-Beam^® Photoeye Kit with adjustable bracket P/N 38176R.S¹
  • Impact-protected Commercial Photoeye Kit P/N OPAKPE.S
  • MillerEdge ME/MT/CPT (DC or T3) 2-wire edge sensor. Must be used with TCM (OPABTCGX.S) or Interface Module (OPAKMEIGX.S).
  • Nema 4 Photoeyes P/N OPAKPEN4GX.S

1 — Default device when operator is ordered.